- 1 Do Sonicare toothbrushes have batteries?
- 2 How do I clean my Sonicare toothbrush button?
- 3 How do I fix my Philips Sonicare loose shaft?
- 4 What is the life expectancy of a Sonicare toothbrush?
- 5 What do you do if your Sonicare won’t charge?
- 6 Why won’t my Sonicare toothbrush head come off?
- 7 Do all Sonicare brush heads fit?
- 8 Why does my Sonicare toothbrush head keeps coming off?
- 9 What is the black stuff in my electric toothbrush?
- 10 What is inside a Sonicare toothbrush?
- 11 Why is my Sonicare light flashing?
- 12 Can a Philips Sonicare be repaired?
- 13 How do I fix the button on my Philips Sonicare toothbrush?
- 14 How do I fix a noisy Sonicare toothbrush?
Do Sonicare toothbrushes have batteries?
The rechargeable battery inside your Philips Sonicare Toothbrush cannot be replaced. If you are discarding your Sonicare Toothbrush, you can remove its battery to recycle it. For instructions on how to safely remove the battery of your toothbrush please consult your user manual.
The power button is stuck Clean the power button and the area around it with a damp cloth to make sure it is free of debris. We recommend removing the brush head after each use and rinsing the brush head and the handle under water to remove residue.
How do I fix my Philips Sonicare loose shaft?
If its lose, just tighten the screw and you’re good to go. If it’s broken off, just go to Amazon.com and type: Metal Shaft for Diamond Sonic Care Toothbrush and you will find a replacement part for under $25.00. It’s just that simple. Be careful removing the water proof rubber sealants on the old shaft.
What is the life expectancy of a Sonicare toothbrush?
The average lifespan of a Sonicare toothbrush, according to consumers, is anywhere from two to five years, though they are said to occasionally last up to seven.
What do you do if your Sonicare won’t charge?
If the battery will not recharge, the entire Sonicare toothbrush must be replaced. Place the bottom of the Sonicare toothbrush into the charger. Plug the charger into a live outlet. Allow the toothbrush to charge for 24 hours.
Why won’t my Sonicare toothbrush head come off?
To remove a brush head that’s stuck on your toothbrush, try running the toothbrush’s top section under warm water for at least ten seconds. Then, see if you can pull it off. You might have to give it quite a forceful tug, but it should come right off.
Do all Sonicare brush heads fit?
All Sonicare models are interchangeable with the others when it comes to brush heads. So you won’t have to worry too much about whether or not a specific brush head will fit your brush handle.
Why does my Sonicare toothbrush head keeps coming off?
Brush head is not attached properly Ensure that the brush head is inserted properly and aligned in the same direction as the front handle. Note: There will be a small gap between the brush head and handle. This is normal.
What is the black stuff in my electric toothbrush?
It’s mold, which likes to grow where there is standing moisture. After you clean the toothbrush container, you can help to slow down the reformation of mold by doing a more vigorous job of shaking off your toothbrush before putting it in the holder.
What is inside a Sonicare toothbrush?
Underneath the motor, there’s a rechargeable battery. Attached to the inner plastic case, there’s a simple electric circuit board that controls the on/off switch on the outer case. The outer case is made of tough plastic and the on-off switch is set into it in a piece of thin, very flexible rubber.
Why is my Sonicare light flashing?
If you see the battery indicator light blinking, or if you hear a beep, it means that your toothbrush is charging. Fully charge your Philips Sonicare Toothbrush for 24 hours. If the flashing light turns off at some point during charging, this is normal.
Can a Philips Sonicare be repaired?
If your Philips Sonicare electric toothbrush product is defective during the warranty period, Sonicare will repair or replace it free of charge.
If the button cannot be pressed, there may be something below the button holding it down. To fix this, remove the brush from the toothbrush. Then, remove the bottom of the casing with a flat head screwdriver. If holding the toothbrush, lights facing up, depress two prongs in either side inside of the toothbrush.
How do I fix a noisy Sonicare toothbrush?
Brush head not attached properly Reattach the brush head. Make sure that the brush head is well placed and not loose or wobbly. A small gap between the handle and the brush head is normal. This is needed for vibration.