- 1 How do you remove a spinbrush head?
- 2 How do you clean Braun Oral B?
- 3 Can I replace the battery in my Oral-B electric toothbrush?
- 4 Why is my Oral-B electric toothbrush not working?
- 5 Why does my Oral-B electric toothbrush turn on by itself?
- 6 Why does my electric toothbrush stop and start?
- 7 Should you leave your electric toothbrush on charge?
- 8 How do you take apart a spinbrush toothbrush?
- 9 How long does a spinbrush last?
- 10 Are Arm and Hammer Spinbrush heads interchangeable?
- 11 What is the black stuff on my toothbrush?
- 12 Why is there yellow stuff on my toothbrush?
- 13 How do you get mold out of an electric toothbrush?
How do you remove a spinbrush head?
To replace the brush head, twist counterclockwise 90° and pull away from the handle. Slide on new Spinbrush replacement head and turn clockwise 90° until arrows are aligned.
How do you clean Braun Oral B?
While the toothbrush head is soaking, wipe down the handle with a mild cleanser or bleach solution to remove excess gunk (use a cotton swab-dipped solution to clean out the area where the head is attached). When 30 minutes have passed, rinse both the toothbrush head and handle with warm water.
Can I replace the battery in my Oral-B electric toothbrush?
No, you cannot replace the battery in your Oral-B electric toothbrush. The battery is contained within the electronics of the toothbrush handle and the unit is then sealed to keep it water tight. For these reasons we do not provide replacement batteries for Oral-B electric toothbrushes.
Why is my Oral-B electric toothbrush not working?
The best thing to do is to put it on the charger for 30 minutes or so, and then try to switch it on. It should blink green during charging. Note that this can take up to 15 minutes to start happening if the toothbrush was entirely drained of battery during brushing. When charging is complete, the blinking should stop.
Why does my Oral-B electric toothbrush turn on by itself?
Oral-B toothbrush power cycles on/off If the Oral-B toothbrush is turning itself on and off very quickly, and then continues to run this likely normal. This is the professional timer, also known as the pacer/quadpacer/30 second timer.
Why does my electric toothbrush stop and start?
At the end of the 2 minute cleaning cycle, the motor in the brush pauses and restarts briefly three times. This is your signal that the 2 minutes of brushing time has been achieved. Normally at this point you would turn the toothbrush off, by holding the power button for 1-2 seconds.
Should you leave your electric toothbrush on charge?
If this is your first time using the product, you should fully charge the battery before using, which can take up to 16 hours. Once your handle is fully charged, continue using your electric toothbrush until no charge is left. This will help your battery perform at its best longer.
How do you take apart a spinbrush toothbrush?
Remove the end cap from the bottom of the toothbrush by prying it off with a spudger. Remove the top cap by using a spudger to pry the plastic ring off of the toothbrush frame. Push on the rotating head in order to pop the assembly out of the black plastic casing.
How long does a spinbrush last?
If you brush for 2 minutes twice a day, expect the batteries in your Spinbrush™ to last about 4 to 6 weeks.
Are Arm and Hammer Spinbrush heads interchangeable?
Spinbrush Pro Clean replacement heads may be used on other ARM & HAMMER™ Spinbrush™ toothbrushes that have replaceable brush heads, except for Spinbrush™ Sonic and Spinbrush Pro Clean Sonic Recharge.
What is the black stuff on my toothbrush?
Mold on your toothbrush can be both visible and invisible to the human eye. With many bristles and grooves, mold can hind in your toothbrush at microscopic levels. However, it can also appear visible as black goop or pink slime. Many times, mold may form visibly on the bottom of your brush due to being stored in a cup.
Why is there yellow stuff on my toothbrush?
The yellow build-up on your teeth, known as dental plaque, is the biofilm that the bacteria created. Since your toothbrush is physically brushing off this bacteria from your teeth, it is considered to be a potential source of infections and reinfections in your mouth and body.
How do you get mold out of an electric toothbrush?
Soak the brush head. Make either a peroxide, vinegar, or bleach solution and submerge your brush head in it. This can not only remove and kill mold, but also any lingering bacteria that could infect your oral cavity. Wipe the base of the head before soaking it to help the solution more effectively remove other gunk.