Contents
- 1 How do you change the spinbrush head?
- 2 When should I replace my electric toothbrush head?
- 3 Can batteries be replaced in Oral-B toothbrush?
- 4 Why does my Oral-B electric toothbrush turn on by itself?
- 5 Why is my Oral-B electric toothbrush not working?
- 6 How do you clean a spinbrush head?
- 7 How long should you keep an electric toothbrush?
- 8 Are Arm and Hammer Spinbrush heads interchangeable?
- 9 When should I replace my Oral-B brush head?
- 10 Are Braun and Oral-B toothbrush heads interchangeable?
- 11 Why does my electric toothbrush stop and start?
How do you change the spinbrush head?
To replace the brush head, twist counterclockwise 90° and pull away from the handle. Slide on new Spinbrush replacement head and turn clockwise 90° until arrows are aligned.
When should I replace my electric toothbrush head?
Plan to change out the toothbrush head on your electronic toothbrush every 12 weeks, or even earlier. Watch for signs of wear and tear on the bristles to know when it’s time to say goodbye to a brush head.
Can batteries be replaced in Oral-B toothbrush?
No, you cannot replace the battery in your Oral-B electric toothbrush. The battery is contained within the electronics of the toothbrush handle and the unit is then sealed to keep it water tight. For these reasons we do not provide replacement batteries for Oral-B electric toothbrushes.
Why does my Oral-B electric toothbrush turn on by itself?
Oral-B toothbrush power cycles on/off If the Oral-B toothbrush is turning itself on and off very quickly, and then continues to run this likely normal. This is the professional timer, also known as the pacer/quadpacer/30 second timer.
Why is my Oral-B electric toothbrush not working?
The best thing to do is to put it on the charger for 30 minutes or so, and then try to switch it on. It should blink green during charging. Note that this can take up to 15 minutes to start happening if the toothbrush was entirely drained of battery during brushing. When charging is complete, the blinking should stop.
How do you clean a spinbrush head?
Squirt a few drops of soap on your fingers or a toothbrush and scrub the bristles and crevices first. Don’t worry about harming the brush head — the bristles are built to take some abuse. Rinse with warm water and repeat with the handle. Both Prather and Shamban say any soap will do — even dish soap.
How long should you keep an electric toothbrush?
Many dental professionals recommend changing your toothbrush about every three months, and the American Dental Association (ADA) recommends that you replace your toothbrush approximately every three to four months, or sooner if the bristles are frayed.
Are Arm and Hammer Spinbrush heads interchangeable?
Spinbrush Pro Clean replacement heads may be used on other ARM & HAMMER™ Spinbrush™ toothbrushes that have replaceable brush heads, except for Spinbrush™ Sonic and Spinbrush Pro Clean Sonic Recharge.
When should I replace my Oral-B brush head?
Dentists recommend replacing toothbrush head every 3 months, as the bristles become frayed and worn with use which reduces the cleaning effectiveness of the toothbrush. Many Oral-B brush heads refills feature indicator bristles that fade halfway to help remind you when to replace your toothbrush head.
Are Braun and Oral-B toothbrush heads interchangeable?
Are Oral-B brush heads interchangeable? One of the fantastic things about Oral-B brush heads is that they are fully interchangeable*. This means that if you have any of the Oral-B electric toothbrushes, you can use any of the brush heads explained here.
Why does my electric toothbrush stop and start?
At the end of the 2 minute cleaning cycle, the motor in the brush pauses and restarts briefly three times. This is your signal that the 2 minutes of brushing time has been achieved. Normally at this point you would turn the toothbrush off, by holding the power button for 1-2 seconds.