- 1 How do you clean the inside of a Sonicare toothbrush?
- 2 How do you take apart a spinbrush toothbrush?
- 3 What is the lifespan of an electric toothbrush?
- 4 Why won’t my Sonicare toothbrush head come off?
- 5 When should I change my Sonicare brush head?
- 6 Do all Sonicare brush heads fit?
- 7 How do I fix a noisy Sonicare toothbrush?
- 8 Can I change the battery in my Sonicare toothbrush?
- 9 What is the black stuff in my toothbrush?
- 10 What is the lifespan of a Sonicare toothbrush?
- 11 What is inside a Sonicare toothbrush?
How do you clean the inside of a Sonicare toothbrush?
- Remove the brush head.
- Rinse the bottom of the brush head with warm water.
- Rinse the metal shaft area with warm water.
- Wipe the entire surface of the handle with a damp cloth.
How do you take apart a spinbrush toothbrush?
Remove the end cap from the bottom of the toothbrush by prying it off with a spudger. Remove the top cap by using a spudger to pry the plastic ring off of the toothbrush frame. Push on the rotating head in order to pop the assembly out of the black plastic casing.
What is the lifespan of an electric toothbrush?
The average life span of an electric toothbrush is around 5 years. Manufacturers normally offer a 2 year warranty should the brush fail sooner. But some brushes will last a lot longer — we know of people still using electric toothbrushes that are 10 years old.
Why won’t my Sonicare toothbrush head come off?
To remove a brush head that’s stuck on your toothbrush, try running the toothbrush’s top section under warm water for at least ten seconds. Then, see if you can pull it off. You might have to give it quite a forceful tug, but it should come right off.
When should I change my Sonicare brush head?
It is recommended to replace your Philips Sonicare Brush Head every three months of normal use (brushing twice a day) or when the blue indicator bristles wear out. One reason is because brush heads can get weary and will be less effective in removing plague.
Do all Sonicare brush heads fit?
All Sonicare models are interchangeable with the others when it comes to brush heads. So you won’t have to worry too much about whether or not a specific brush head will fit your brush handle.
How do I fix a noisy Sonicare toothbrush?
Brush head not attached properly Reattach the brush head. Make sure that the brush head is well placed and not loose or wobbly. A small gap between the handle and the brush head is normal. This is needed for vibration.
Can I change the battery in my Sonicare toothbrush?
The rechargeable battery inside your Philips Sonicare Toothbrush cannot be replaced. If you are discarding your Sonicare Toothbrush, you can remove its battery to recycle it.
What is the black stuff in my toothbrush?
Mold on your toothbrush can be both visible and invisible to the human eye. With many bristles and grooves, mold can hind in your toothbrush at microscopic levels. However, it can also appear visible as black goop or pink slime. Many times, mold may form visibly on the bottom of your brush due to being stored in a cup.
What is the lifespan of a Sonicare toothbrush?
The average lifespan of a Sonicare toothbrush, according to consumers, is anywhere from two to five years, though they are said to occasionally last up to seven.
What is inside a Sonicare toothbrush?
Underneath the motor, there’s a rechargeable battery. Attached to the inner plastic case, there’s a simple electric circuit board that controls the on/off switch on the outer case. The outer case is made of tough plastic and the on-off switch is set into it in a piece of thin, very flexible rubber.